Endar Spire Hull Repairs 1.4

Start as you mean to go on. For KOTOR, that apparently means leave lots of holes in your level geometry. This mod plugs some gaps in the hull of the Endar Spire, and fixes a few UV issues.

N.B. - THIS MOD IS NOW SUPERSEDED BY THE K1 COMMUNITY PATCH. DO NOT USE THIS MOD IF YOU ARE USING K1CP. IT ALREADY INCORPORATES ALL THESE FIXES, AND MORE BESIDES.

Fixes:

• Plugs two strips that run along either side of the dead-end corridor on the Command Deck that are open to space. These are hard to see, but noticeable just above the windows in this section. Additionally, an alteration to the model's hierarchy was made so that the light strips now correctly animate.
• Removes an extraneous strip of mesh that was causing z-fighting issues (i.e. flickering) in the central corridor where the Jedi vs Sith fight occurs.
• Plugs two gaps in the room just before the escape pods in the Starboard Section. Additionally adjusts the lightmap UVs to remove a light bloom that occurred during baking due to the offset geometry.
• Fills some holes in the forked section of corridor in the Starboard Section just before the escape pod room. Also fixes some flipped UVs causing inverted wall trim textures in this area.
• Corrects some misaligned polys in an inset panel in the end wall of the escape pod room in the Starboard Section. Also adjusts the lightmap UVs of said polys to correct their baked lighting.
• Fixes some UVs causing inverted wall panel textures in a couple of corridor sections on both the Command Deck and Starboard Section.

Installation:

• Simply copy the model files across to your Override folder

Acknowledgements:

• Thanks to @JCarter426 for initially hunting down these holes and pointing them out to me
• Thanks to @ebmar for finding a number of additional issues
• Thanks to @bead-v for KOTORMax and MDLEdit